sunnyasfen.blogg.se

• #Lightworks split clip how to

With the audio track disabled, press U again. You could also press the corresponding number on your keyboard to disable the track, 1 being you video track and 3 being the audio track (2 doesn't count because it's a stereo track). Press Tab to rejoin the edit and disable trim mode, then turn off the audio track by clicking on the label to the left of the timeline.

Lightworks will try to apply whatever trim command you give it to any active layers, so if we only want to move the video cut, we need to first disable the audio track. But wait! We only wanted to move the video cut, not the audio cut. See how the clips seem to fold into the cut? That's Lightworks subtly telling you that it is going to add footage to the left side and take it away from the right side, essentially moving the cut point. Position the playhead on the cut that you want to adjust (remember that you can use the A and S keys to snap the playhead to cut points).

Because our assembly edit has the audio positioned more or less where we want it, we'll leave that alone and only move the video split to create a J-cut. Not only does this make our editing more transparent, it allows us to reveal the reactions of our characters to the conversation. Alternatively, we see the new character and prepare for the speaker to change. We hear the audio and subconsciously prepare ourselves for the cut. This slight overlapping of video and audio helps our brain cope with the edit. To understand the naming convention for these cuts, it's best to see how they look on a timeline. So really, it's one technique that is mirrored. An L-cut is just the opposite we see a clip before we hear the audio. With a J-cut, we hear the sound from a clip before we see it. Two very powerful techniques are J and L cuts. There are several techniques for "softening" a cut to make them less noticeable. Unless the film stylistically calls for an editing approach that celebrates the involvement of an editor, the goal is to be as invisible as possible. It's nothing a bit of advanced trimming can't fix. Not to mention hard cuts between each line of dialogue is rather disorienting, predictable, and frankly quite boring. A change in speaker is certainly new information, but sometimes a character's reaction is even more important, and we don't need to see the speaker at all. This also makes sense if you are following the general editing rule to only cut when new information is presented. When creating an assembly edit, it's best to cut for audio and not be too concerned about how the video looks.

#Lightworks split clip how to

So I hope that after you read this article you now know how to Cut and trim a video.If you followed the basic timeline editing tutorial, you should now have a very rough assemblage of clips on your Lightworks timeline. When they’re highlighted click on them and drag the ends to where you want them to be: ConclusionĬutting and trimming a clip is a very important part of video editing, and it’s also one of the easiest task to perform, in this article we talked about how to do it on lightworks video editing softwar. To trim a clip on lightworks all you need to is to hover the mouse over the ends of the clip you want to trim until they’re highlighted. Once you’re all ready you can export your video by right clicking on The “ALL” option on the lower left part of the Timeline, and then clicking on the “Export” option: How to Trim a Clip on Lightworks To do that you need to select that part you don’t need left click using your mouse and choose the ” Delete ” option or by just simply clicking the “delete” button on your keyboard: Export the video And to do that you need move the play head to where you want to cut your clip and simply click “C” on your keyboard: Delete the unwanted partĪfter you cut the part you need, you have to delete the part you don’t need. After you upload your clips to the timeline you start cutting your clips.